Preparation and Cleaning
Remove the base rock and racks, scrape out any debris from last season. To prevent grease marking the patio, this is best done on the lawn. Alternatively, if the rocks or bricks are very greasy, turn them over and burn off the residue. Then replace, according to manufacturers instructions.
Ignition
Spark ignition failure is a common occurrence after the winter break. To rectify the problem you should:
Check the ignition cable is pushed well onto the connections at both ends. Clean the tip of the ignitor and the area around it.
If the barbecue still fails to light, try lighting it manually according to the manufacturers instructions. If successful, this will confirm that the problem lies with the ignitor.
Blockages
Brush the holes in the burner with a stiff brush to remove any build up of grease. As spiders seem to be attracted to barbecues, check for webs and eggs as these can restrict the gas and airflow.
Check the gas supply pipes and if you see cuts and cracks have them replaced by a Calor Gas dealer.
Sometimes problems are experienced with flare up. This can be identified as a yellow tipped creeping flame, often with a smoky tip. In many cases this is due to low pressure, caused by dirty or blocked burner parts, or in some cases, dirt and grease around the area of the gas jets. Cleaning will generally rectify this.
|